Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All
We have purchased the Cisco catalyst 9300 switches and replacing them with HP5500. The switches will be used as Core in the network. I haven't worked on these switches before and looking some help in stack configuration.
Please share the sta...
Hi
I have pair of WLC 5520s connected to Nexus 2K. The management port of the WLC is configured in VLAN78. And the switchport of the Nexus switch is configured as access port and also configured for VLAN78 but i am unable to ping the WLC management I...
Hi
I have connected my New Pair of Cisco WLC 5520 controllers with Nexus 7K. I connected Port1 & Port2 (10Gig Ports) from each controller back to Nexus 7K. Ports on the switch are part of Port-channel but when i look the status of the ports on the s...
Hi
I have exiting 3 pair of 5508 controllers and there are almost 760 APs in the environment. Now we have a new pair of Cisco WLC 5520 and i want to migrate all these APs to the new controllers. The new pair of 5520 WLC will be configured as brand ne...
Hi EveryoneWe are going to implement the VDI access for our customers and i need to implement the QoS for PCoIP in the network. We are using VoIP in our system. So i am looking for the QoS configuration that i can configure for these services. I want...
Hi Francesco
Thank you for your kind reply. i am going through the documentation and will get back if i have any query. I really appreciate your help.
Thanks again.
Best Regards
HiCisco WLC 5520 doesnt support VPC on nexus just for the information. Also you need SFP-10G-SR, i used these to connect the ports. Make sure you enable LAG mode on controllers and reboot. Also connect your controller in this way:1. Connect both port...
I am surprised that no one mentioned that this Management port is not the port which we use for GUI. I didn't find it till i went into details. So the management port on WLC5520 is not the port which we use to access GUI. This is for out of band mana...
Thank you for your reply. So that means we don't need to connect that management interface on back of WLC 5520 with our core switches. right?
Actually i am having a issue accessing the WLC GUI via management IP. can you please help what could be th...
When i am reading a documentation i am confused. So according to the document here is what my understanding is:
Cisco WLC 5520 Rear Panel Ports:
1) 2 USB ports
2) CIMC Port (Marked with 'M')
3) Console Port
4) Service Port
5) Redundant Port
Ok s...
