Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hiI configuring the parameters in the switch for snmp v3 and the cisco prime, but i don´t have any responsebut, I configure snmp version1 this work in the scree on the cisco prime, don´t appear this field´s to configure all parameters for snmpv3 any ...
Hi i have a problem with this, the access to via ssh is very slowthe times for pin is very high, but in my network this problem is with only Cisco 2950, i have in my network cisco 2960 and I not have this problem Respuesta desde 130.2.200.12: bytes=3...
hithis procedure don´t work http://www.cisco.com/c/en/us/support/docs/wireless/aironet-1200-series/9215-pwrec-2.htmlI use the recommended combination key of teraterm, putty and hyperterminal and do not pass anythingi use a windows 7any idea??
I don't downgrade the IOS, beacuse I lost the conexion via ssh, and this is the requeriment for my information security department I do think the change my all switch 2950 to 2960, what do you think? thanks
HiI review the broadcast in the 2960 an this is a result.GigabitEthernet0/1 is up, line protocol is up (connected) Hardware is Gigabit Ethernet, address is 0017.950a.bab1 (bia 0017.950a.bab1) Description: Cascada 200.12 MTU 1500 bytes, BW 100000 K...
hi, thanks for your answer # sh arp | in Incomplete# sh arpProtocol Address Age (min) Hardware Addr Type InterfaceInternet 130.2.17.148 0 0050.5696.000d ARPA Vlan1Internet 130.2.18.132 0 18a9.0570.d29a A...
