Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I would like to have your suggestions concerning Cisco routers that support STM1 Cards. I am looking for a router reference (product or part number) that supports 2 STM1 cards maximum, at least 4 GigaBitEthernet Ports and must support security fe...
Hi everyone, a week ago a strange behavior happened on my network where an STP loop occured on two different spanning-tree vlan instances causing the isolation of 4 switchs at the same time (errdisable). Here's the log on PSW01, PSW02, BSW01, BSW02 (...
Hi Philip,
yes indeed, stacking them together will solve many problems and will also increase the performances. I will think about this solution. Thank you for your help, I very much appreciate it.
HelloThe distribution switch isn't the root bridge, because most of the traffic goes between PSW01 and PSW02, we made PSW02 the root bridge so the traffic would flow throughout GigaEthernet ports instead of fastEthernet.
Hi mark, so from your response I understand that the distribution switch may not have received the superior BPDU from PSW02. And if that was the reason of the problem, why would PSW01 put its interface (Gi0/23) in errdisable mode since it's not the r...
Hi paul, thanks for replying, all unnecessary vlans are pruned and of course I will apply UDLD aggressive on all trunks to avoid any future problems, but i would like to find an explanation to the problem that occurred.
Hi Philip, thank you for replying, I am using a cisco catalyst 3560 (IOS C3560-IPSERVICESK9-M, Version 12.2(55)SE6), and the other four switchs are cisco C2960 (IOS C2960X-UNIVERSALK9-M, Version 15.0(2)EX3). The spanning-tree algorithm being used is ...
