About austin.lechelt

austin.lechelt · 01-20-2017

I have two questions regarding this subject; first, why doesn’t it work when referencing ACL’s in two different NAT statements on a Cisco ISR router? !---Routing and interface configurations omitted--- !ip nat inside source list NAT_172.16 interface...

austin.lechelt · 10-01-2016

I have a 5506-X connected to a switch, connected to a router. There’s only one public IP address, which is on the router, and the router is handling the NAT. The ASA is forwarding traffic without the use of NAT. There is a NAT statement in the router...

austin.lechelt · 01-21-2017

Thank you! I have one additional question; I tried the route-map: route-map isp1 permit 10 match interface FastEthernet0/0 !route-map isp2 permit 10 match interface FastEthernet1/0 ...and it works! From my understanding the statement: route-map is...

austin.lechelt · 10-01-2016

Without having more information, i.e. configuration outputs, I’m going to make some assumptions (cause that’s never resulted in my wife yelling at meJ). 1st it sounds like your internal networks are referenced in the ACL that’s referenced in the gr...

Member Since	‎07-02-2014 07:19 AM
Date Last Visited	‎10-07-2017 03:01 PM
Posts	4

User Statistics

User Activity

NAT for Dual WAN Interfaces Using ACLs

SSL VPN on ASA Behind a Router

Thank you! I have one

Without having more