Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I am using 5 Cisco 2960-X switches that are stacked. However, the logical and physical order of switches is wrong (I.E. the top switch is switch 3, second from the top is switch 4, etc). I have fixed that by changing the priorities so that next ...
Hi, We use a lot of Cisco 887s (with ATM ports) and sometimes need to flap the interface (to accomplish the equivalent of power cycling a modem). If we have two connections, we just go through the other one and issue shut/no shut. If we only have one...
Thanks Leo. That's a help. I was kind of hoping there was a command that would reset the interface making shut/no shut unnecessary. The purpose of this is just to drop the DSL connection and re-initiate it. I'm going to try doing this with EEM. Thank...
Thanks for your help. I'll try scripting an EEM tomorrow. The issue with EEM is that we are a WAN solutions provider. The amount of time to set up an EEM on all of our devices would take a long time. I'm definitely going to try this. Thanks for the h...
