Is there a way to switch a 5509 to store and forward mode, so when I span a port I can see the errors come in on a port? I have a remote sniffer attached to the switch to save me from going to the remote location. But I can't see the errors comm...
How do we get the MSFC3 to be seen by the switch?Doing a show mod shows the sup eng but not the MSFC. Inthe older sup 1 you could get to the MSFC with the sessions comand. Doing session command with sup 720 weget "module not installed". Thoughts...
Using the com port on an XP machine, to console into an IOS switch, the up arrow to repeat the last command does not work properly. Anybody else have same problem?
Thanks for the info. After I submited the question I thought "hey stupid, it is in store and forward. I need it to be in cut through. DUHHHHH. Normally I would just take the portable sniffer out and attach it to the hub. In this case somebody "h...
Thanks for the info but I still see no errors on the sniffer. Though the counter on the switch sees them. Of course if the errors occur before the first 2 bytes of the destination mac, the sniffer wont see it. I'll keep looking.
