Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Everyone,
My question is gonna be related to DMV spoke configuration, i used to setup a new spoke router that has the IOS 15.1(4)M10 in cisco 871-k9 plateform, the router accepted all the command and i figure out that the VPN state remain in NHR...
i've configured the route-map on a catalyst switch 4503E but when i checked the configuration i can't see the next hop see below the output of show route-map ML-SW-1#show route-map route-map test, permit, sequence 10 Match clauses: interface Fast...
Hi everyone,i've tried to setup my router to boot the IOS system from a tftp server,1) So first configured my router from the rommon like this :rommon 3 > tftpdnld -r IP_ADDRESS: 192.168.1.1 IP_SUBNET_MASK: 255.255.255.0 DEFAULT_GAT...
Here it is :Hi Rachid,As per your request find below the output of show versionML-SW-1#sh versionCisco IOS Software, Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 15.0(2)SG10, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisc...
