Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have been looking for some information regarding large platforms for NAT rollout. I have look at information for CISCO platforms that allow for HW Assisted or Accelerated NAT however I have not been able to find much. Is there a list or a do...
Hello, I have the following setup:Multiple Border Routers with eBGP sessions to external AS. We receive a default route from this multiple AS to keep the Table manageable. We noticed an important part of our traffic was been SW routed instead of CEF...
Well we are certaint it's a codec issue. Now codec issues can happen due to a range of conditions. We will need debug CCSIP messages from the call to see what codecs were offered on both sides, also a debug voip ccapi inout would be ideal to identify...
I would start with a traceroute and a show ip route when you have the local pref modified and giving you headaches. Otherwise its just shooting in the dark.Cheers,
Well you need a call agent. This can be either CUCM or CME. I think CME is suitable for your setup. Look for the maximum amount of phones and ephones you can support on the 3900 platform you are planning to acquire. Also a CUE module is a nice Voice...
You always need to prepend with your own AS multiple times. No you cannot use random AS numbers, as this could really confuse the world wide routing table. Also those 'random' AS numbers might be valid AS that belong to someone else.Its always best...
You will need one of this.http://www.cisco.com/c/en/us/products/collateral/routers/3800-series-integrated-services-routers-isr/product_data_sheet0900aecd80394b7e.html
