Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, we recently over the summer upgraded from 8.6 to 11.5 CUCM. Recently we've had a few user cases that have complained about receiving a call internally, and then not being able to hear the other end for a couple seconds. Their sometimes seems...
Hello,
We currently have a single-homed fex topology consisting of 2 N5ks with 2 N2ks (image attached). We are looking to purchase a new ucs c220 server to connect by NIC teaming to the 2 N5ks. Usually every time I look at online guides for how t...
Hello our Core switch has all routed links connecting to it. It seems that every time I open a putty session and enter the IP address of any of those routed links, I can access the switch. I would like to only access the switch from the managment i...
Hello,We have a mulcitast server that is firewalled but does not pass multicast traffic from the firewall to the n5k switch. It only passes the mulitcast traffic when we take the multicast server off the firewall. I'm presuming this is so becasue i...
Hello, I have a couple users on a 3850 switch that sometimes randomly are talking to someone and only hear every other word (choppy cutting in/out ). I've replaced the phones (6921), handsets etc.. ethernet cords, switchports etc.. I've also checked...
Did you ever figure out the issue? Our CUCM version is 11.5
Sometimes there is no audio delay, sometimes there is a 10+ second audio delay, and sometimes there is no audio at all. The phones also don't always get the signal from informacast to jo...
ok how do I adjust the pcap syntax to do SCCP phone capture? Also is their a way that I can specify the stream instead of capturing everything on the registered CM?
