Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello Our Current UCS firmware is at 2.2 (5b) and are planning an upgrade to 2.2 (8g), and are currently using the B200 M3 and M4 Model Servers and running Esxi 6.0.U2 with Version: Version 1.6.0.25 fnic & Version: Version 2.3.0.7, enic drivers. A...
We have a mix of B200 M3 and B200 M4 servers a total of 20+ Blades running currently on 2.2(5b) UCSM Version and with a recent Infosec update we need to fix some Vulnerabilities with Vmware and wanted to know if can just upgrade the Server Blades to ...
Hi We are setting our New Hitachi Storage, and wanted to know if we need to use Lun ID as 0 for boot lun ? or can we have any number as the Lun ID . Please review and respond.
A
lso can i just have only one WWN each for the Primary and Secondary Tar...
Please review If i can follow the below steps.
1- Create a New Boot Policy
2- Modify the Updating Service Profile template to use the New Boot Policy.
3- With Maintainence Policy Setup to UsrAck, When I Ack and reboot a single host the new boot pol...
Please review If i can follow the below steps.1- Create a New Boot Policy2- Modify the Updating Service Profile template to use the New Boot Policy.3- With Maintainence Policy Setup to UsrAck, When I Ack and reboot a single host the new boot policy w...
Additional Information I am revieng the Internal Dependencies for upgrade from 2.2 (5b) to 2.2 (8g) and the table shows Minimum Qualified Software Version & Recommended Software Version. What does this Say can u give an example and will it affect my ...
Understood, to clarifiy further. I need to upgrade the enic/fnic only after a server firmware is upgarde not otherwise, as i will have to plan it out on multiple days. After the Infrastructure is upgraded.
Thanks for the details, also is there something quick to share about known issues with the upgrades to the version, apart from reading the release notes for the ver.
Thanks for the responses, i would like to add some clarification so to achieve my work.We would like to plan our Vmware Esxi Env to VMware Vsphere 6.0 Update3 and understand that we need to be at 2.2 (8g). Current UCSM running at 2.2(5b) With B200 M3...
But if I have multiple hosts using the same template this change will cause all Esxi hosts to reboot correct ?
How do I manage 1 host at a time.
Regards
navin
