Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an Aironet 1852i, with Mobility Express pre-installed (and confirmed to be in ME mode), and I am trying to configure it with 2 wlans for our internal domain networks (both using Windows RADIUS, and both on seperate vlans with seperate external...
Ok, I am glad to see that I am not the only one in this boat! (but saddened at the same time)
I'm using PI 3.3, and have been pulling my hair out trying to find some way to have it produce some fairly simple bandwidth usage reports/details (the sam...
It looks like you are correct, pieterh.
Right after submitting my initial post (and reading it back to myself again), I stumbled across the Cisco Wireless Controller Configuration Guide v.8.3 (NOT the Mobility Express Configuration Guide v.8.3!!). ...
I did manage to figure the problem out, at least for my case.
For me, the problem had to do with DHCP for the management interface. All my network devices are statically assigned a management IP (on my management subnet). Which is exactly what I di...
Same exact issue here.
Day 0 power up and initial configuration of ME on an AP1852i-A-K9, via the web console (over the default setup SSID). Completed the initial config steps (with test "employee" & "guest" networks), and the wizard reloaded the d...
