Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
my configOn the dst port i can only see one direction (tx) traffic to the source port. Why would that be? M1# show running-config interface ethernet 1/19!Command: show running-config interface Ethernet1/19!Time: Fri Sep 12 13:57:45 2014version 6.0(2)...
I am trying to configure nexus switch as NTP master, there seems be no master command? How do i configure nexus switch to be NTP master? Thanks.M1(config)# ntpabort authenticate authentication-key commit distrib...
Yes that is correct Akash. My expectation was as I am capturing tx and rx on port Eth103/1/13. I should see on port 1/19 which is monitor port.If that wouldn't not be the case what should I do to capture both tx and rx packets.
