Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi allI'm building an SDWAN lab and one of my scenarios I want to test is dual ISP failover at a branch locationI am confused about how you set up the default routes. I want the default route to switch to the second ISP connection if the primary ISP ...
Hi all I've been trying to get an SD-WAN lab running but i'm finding it very challenging,I've been following this guide:SD-WAN Lab – Part 3 – vEdge Devices - RouterflowI've got the 3 controllers up (vmanage,vbond and vsmart) and they appear to be wor...
Hi allI'm trying to install an SD-WAN lab POC but i'm having problems.I've followed a variety of guides online, i'm building up on my lab ESXI 6.5 host - most lab guides are using EVE-NG but I dont want to use that as it's not how you'd build it out ...
Hello all,I have a lab setup with a Cisco vWLC deployed in VMWare ESXI and 2x 1131 APs, The APs are failing to join the controller due to a certificate error. I have noticed that the time that APs are using is an hour out from the controller.The cont...
Hi all, i'm wondering if you can help me, i'm trying to deploy Cisco Prime Infrastructure in a lab envrionment but it's not working correctly.I've deployed "PI-VA-2.1.0.0.87-Express.ova" to a VMware ESXI 5.1U2 hypervisor with 2x AMD 8128HE CPUs, 96GB...
Thanks for that - I missed that part in the guide! Weirdly enough, before your reply, I upgraded the vEdge to 20.5.1 and my setup using the same tracker actually started working without any changes... but I will use 2 different trackers in future if ...
Thanks, I got the route tracking working but the NAT doesn't work once failed over Here's my config:S4-VE1# show run
system
host-name S4-VE1
system-ip 9.9.9.9
site-id 4
admin-tech-on-failure
no route-c...
Thanks for the replies everyone, I installed the root CA certificate to the vbond as follows:request root-cert-chain install /home/admin/ROOTCA.pem I also fixed my NTP setup (was using the wrong VPN) so all clocks are fully synchronised The control c...
vedge# show control connections-historyLegend for ErrorsACSRREJ - Challenge rejected by peer. NOVMCFG - No cfg in vma nage for device.BDSGVERFL - Board ID Signature Verify Failure. NOZTPEN - No/Bad chassi s-number entry in ZTP.BIDNTPR - Board ID not ...
The server takes about 30 mins to boot up, it's not actually broken it's just extremely slow .. I have found numerous people reporting this issue online, and our production system also does this! I guess my original problem is solved, although I woul...
