Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I installed a new PID: EHWIC-4ESG on a cisco 2901 , but it is not showing up in the sh ip interface brief Getting below message in the log:EHWIC IPCORE PLL PLL Failed to LOCK in 0/2/0 ehwic slotAny suggestions on how to fix itCisco 2901 version is:...
I have a cisco 9407 rnning 17.3.3 iam trying to configure vrf . when i executed the command ip vrf xyx . it tells me this feature is not supported . is there anything to with licensing ?
When I did this command on a ASR 9904 , p#sh ipv4 interface bundle-ether 11, got below outputMTU is 9196 (9170 is available to IP)trying to figure out , how come this is possible to work. I believe there has to be min (40 ) difference between IP M...
ASR1001-HX Gave an alerts Event: subslot 0/1 transceiver 1 Rx Power Sensor, Anyone know does this error a concern or what command I can use on this platfrom to check the status
sh hw-module subslot 0/1 transceiver 1 statusThe transceiver in slot 0 subslot 1 port 1has been disabled because:the port is in shutdown stateModule temperature = +27.156 CTransceiver Tx supply voltage = 3287.4 mVoltsTransceiver Tx bias current = 0 u...
