Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,
I need some help please.I am trying to configure voip dial peers between two branches while they are in srst mode. Both branches have connectivity through an IPsec VPN tunnel.Branch A has an 2901 ISR router and branch B has an 2921 ISR rout...
Hello everyone,I need to validate this configuration. I have an 2901 ISR router and I am trying to allow skype and mail only to a specific vlan (172.16.4.0/24). The vlan 172.16.20.0/24 has no restrictions. Topology attached. This is what I've done (p...
Hello folks,
I know that regular ip phone registration process is as follow:
1.-The phone has received PoE from the switch.
2.-The phone has received VLAN info.
3.-The phone has received IP info from DHCP server.
4.-The phone has downloaded its ...
Hello guys,
I have a simple question: is there a limit of phone subnets that Busines Edition 6000 can manage? For example the server BE6K is located at Head quarter and there are four branches, every branch have phones registered to BE6K at branch.
...
Hello folks,
I need your wisdom now. I hope you can help me.
This is the thing. I have an HQ and two branches connected through an IPsec VPN. Below the topology.
Branch A has 15 phones, Branch B has 10 phones, HQ has over 100 phones. CUCM is locat...
Hello Chriss,
I was trying with this config first, (when the debug was captured):
voice translation-rule 4rule 1 /^4/ //voice translation-profile strip4translate called 4
dial-peer voice 30 voip translation-profile outgoing Strip4 destination-p...
Hello Chris,
Phones are normally registered with CUCM version 10.5 at HQ. But when phones are registered to the SRST gateway I want to communicate Branch A with Branch B. This is what I am trying to do. I attach de debugs from Branch A because I only...
Hello Chris,
Phones are normally registered with CUCM version 10.5 at HQ. But when phones are registered to the SRST gateway I want to communicate Branch A with Branch B. This is what I am trying to do. I attach de debugs from Branch A because I only...
Hello Julio,I want to know if my configuration it will work before aplying it because I am newbie with class-maps. I pretend to allow skype and mail traffic only to a specific vlan, rest of the traffic must be dropped.
