Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I have an existing setup where in i have a 4400 WLC and AP 1242 registered to it.I had to replace the WLC with a new 5500 WLC. I tried registering the the 1242 AP with this new controller but i'm getting the following error message: AP0026.0b4d.0...
Hi, I have a scenario in which I have an Existing WLC in place. The task is to install another WLC which is going to be in HA with this WLC.The new WLC would be in a different geographical location than the Primary (Existing) WLC. As per my understan...
Hi, I deployed wireless for one of my clients. All services and the internet are working fine.Only problem is that while sending and receiving emails using Microsoft Outlook, there is a huge delay.Even mails as small as 10-15 KB takes a lot of time t...
Hi, My Corporate Headquarters has:1. Cisco 5508 WLC2. Centralized RADIUS serverA MAC address repository is created in the WLC for MAC address authentication. This includes MAC addresses of users from the Headquarters as well as the remote branch offi...
Hi,I'm facing an issue in Cisco 5508 WLC.My WLC IOS image version is 7.5.102.0.Problem statement: My WLC is currently in production and catering to a live system. It has to be migrated from existing data center to another. The IP address, subnet mask...
That is a risk we will have to take because direct connectivity is not possible. Is there any alternative other than N+1 configuration for this scenario? Both the locations (location where primary WLC is currently present and the location where the n...
Direct layer 2 connectivity would not be possible as the distance between both WLCs would be approximately 400-450 kms. I have read about N+1 type configuration. How reliable would that be?
