Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I just recently converted a 9300 over to Cloud Managed mode and setup dual-stack SVIs however after assigning IPv6 addresses to the SVIs I noticed that none of the clients get SLAAC addresses and I can't seem to find anything in the GUI to indicate w...
i've got a Catalyst 9300 I'm testing with Monitored Mode on the Meraki Dashboard. I've got a couple non-Meraki APs connected and I see all the wireless clients on their respective ports but a vast majority of the wired devices never show up at all in...
Just doing some lab testing on the C9300, I migrated one over to Meraki mode but I don't have any ability to configure IPv6 SVIs like I would if I had a MS390 in the dashboard. The release notes for MS15.21.1 say the migrated switches should have the...
That's great to hear @TonyC1 , hopefully it's a easy implementation as SLAAC support, or more directly the current addition by Meraki of "ipv6 nd ra suppress all" on all SVIs, and being able to take that line off would be perfect!
Glad to know that clients at least work in the default VRF getting SLAAC addresses but shame that the vrf for IPv6 routes isn't applied properly. If you get a chance can you get a show run for an SVI in the default VRF and just let me know that route...
Does IPv6 work for your end clients via SLAAC @Thomas Obbekaer Thomsen ?That's the one thing that was blocked on 17.15 that I'm hoping is working in 17.18 in meraki managed mode for me.
