Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Is it a straight forward procedure to downgrade ASA from 9.2(4) to ASA 8.4(7) just to change the boot system ?
There is no IPv6 used at the moment.
Thanks in advance all !
Hi All,
I would like is it possible to have our Branch A site-to-site IPSec tunnel to HQ ISP 1.
All the traffic including the internet traffic from Branch A will have to go through IPSec tunnel to HQ, however in this case all the internet traffic at...
Hi All,
We are using CiscoSecure ACS 4.2 for AAA.
In Our ASA 8.2.5 ASDM 7.3(1)101 , if we login with user group privilege 5, we would not be able to see the firewall dashboard for Top 10 Services / Sources / Destinations.
Anyone knows how to have ...
Hi All,Is it possible to configure static route with 2 Dynamic IPs by ISP DHCP with ASA ?If possible, how the configuration should be ?For example :To route 1.2.3.4 via ISP-1 (dynamic IP)To route 3.4.5.6 via ISP-2 (dynamic IP) ASA Ver 8.2(5) Thanks
So can I assume as follow when creating the IPSec tunnel
HQ
crypto local address 0.0.0.0 0.0.0.0 (any)
remote address 10.2.2.0/24
Branch A
crypto local address 10.2.2.0/24
remote address 0.0.0.0 0.0.0.0 (any)
Do you mind to share the command conf...
Thanks Dina,
Yes on the HQ ASA will have IP SLA, ISP2 is the primary default route except the Public IP of Branch A which will routed through ISP1 with metric 1.
Understand on the Branch A ASA for the PAT, how about on HQ ASA ? what should we do for ...
Thanks Aditya,
I managed to get into priv 5 now with ACS, however with priv 5 i can do modify the config and write memory
below output
FW-C5505# sh curprivUsername : apactestCurrent privilege level : 5Current Mode/s : P_PRIVFW-C5505# sh privFW-C5...
Thanks,
No, I do not have customized privilege on ASA
I am not sure why the user group is only having privilege 1.
Please see below
FW-C5505> sh curprivUsername : apactestCurrent privilege level : 1Current Mode/s : P_UNPRFW-C5505> sh run | begin pri...
