About esteban.r

esteban.r · 05-30-2018

Dear Community I have to install routers IR809 on several sites covered by 3/4G for monitoring and maintenance purpose. These routers must be connected to the monitoring center (MC) by EasyVPN through 4G network. (We cannot setup VPN IPSEC L2L beca...

esteban.r · 06-10-2015

Dear support, I have installed a Wireless LAN Controller 2504 with firmware version 8.0.110 and I have configured a WLAN with web authentication on which users must pass by a proxy server to get internet access. Therefore browsers are manually con...

esteban.r · 06-01-2018

Hello George,You're right.If I specified the default route on the Cellular0 interface, then NVI will automatically consider the cellular0 as outside NAT. When I remove the default route or any static route on this interface, then I can see the legacy...

esteban.r · 05-31-2018

Hello George In my first post, I attached the diagram of my setup. The Monitoring Center use IP subnet 192.168.100.0/24 The Monitoring system is 192.168.100.1 with default gateway 192.168.100.1 (which is the EZVPN server router) On the ot...

esteban.r · 05-31-2018

Hello Georg Thanks for your prompt reply. Please find configuration of EZVPN client before reload and after reload here-enclosed Hereunder the "show version" output: Cisco IOS Software, ir800 Software (ir800-UNIVERSALK9-M), Version 15.5(3)M...

Member Since	‎09-01-2014 02:04 AM
Date Last Visited	‎08-01-2018 02:27 AM
Posts	6

User Statistics

User Activity

Legacy NAT issue against NAT virtual interfaces

web-auth proxy redirect with browser's home page in HTTPS

Re: Legacy NAT issue against NAT virtual interfaces

Re: Legacy NAT issue against NAT virtual interfaces

Re: Legacy NAT issue against NAT virtual interfaces