Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I would reimage 2x Cisco ASA 5545x to FTD version 6.6(the latest supported image).In the link below, Cisco mentioned the last signature update date, but I couldn't find the same for FTD version 6.6.https://www.cisco.com/c/en/us/products/collateral...
Hi everyone,There was a problem with my ASA 5545x firepower service. As a result of reimaging the firepower service, my permanent SFR license was deleted. If I lose the default permanent license, how can I get it back?thanks and regards
Hi everyone I diable some sub-interface in FTD 2120 and deploy the config from FMC. unfortunately the communication between FMC and FTD going through that interface. how can enable sub-interface from fxos/expert mode or roll back the config to the la...
I have been adding a route-map via flexconfig and it worked fine, but when I change some access-list rule or any change not flex config and deploy all route-map configuration still in running-config but the PBR does not work.if I remove the PBR with ...
HelloRecently, on one of our switches, the amount of CPU consumption has increased to 90%.After executing the command show process CPU sorted, I realized that Process RARP had allocated 60% to itself.Can anyone guide me on what this process is and ho...
Hi all,I have a question: if I migrate or export and import the current ISE node into another ESXi host, Is my license also imported?or should export and import lic as well?
Hi balajithanks for replyingunfortunately FTD was in production and it works well, i just disable a sub-interface which it belongs to FMC and FTD communication.
