Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,I am trying to upgrade our Nexus from version nxos.9.3.2.bin to version nxos64-cs.10.4.5.M.bin.with the step 9.3.2>9.3.16>10.5.4M The process seems to be working fine from 9.3.2 to 9.3.16 and switch came up and everything worked fine. but from 9....
Hi,I would reimage 2x Cisco ASA 5545x to FTD version 6.6(the latest supported image).In the link below, Cisco mentioned the last signature update date, but I couldn't find the same for FTD version 6.6.https://www.cisco.com/c/en/us/products/collateral...
Hi everyone,There was a problem with my ASA 5545x firepower service. As a result of reimaging the firepower service, my permanent SFR license was deleted. If I lose the default permanent license, how can I get it back?thanks and regards
Hi everyone I diable some sub-interface in FTD 2120 and deploy the config from FMC. unfortunately the communication between FMC and FTD going through that interface. how can enable sub-interface from fxos/expert mode or roll back the config to the la...
I have been adding a route-map via flexconfig and it worked fine, but when I change some access-list rule or any change not flex config and deploy all route-map configuration still in running-config but the PBR does not work.if I remove the PBR with ...
Hi everyoneI had the same issue on VMware ESXi. A reboot did not help, and there was no rollback either.Fortunately, I had a snapshot and was able to restore the node back to the base 3.4 version. After that, I tried installing Patch 2 for testing, a...
Hi all,I have a question: if I migrate or export and import the current ISE node into another ESXi host, Is my license also imported?or should export and import lic as well?
