In order to join the FI to the cluster, it is required for both the FIs to be in the same firmware version.
But upgrading the firmware on your current standalone FI will cause an outage to the servers connected to it as there is no redundancy during ...
In cluster mode, if the primary does not detect that a secondary FI is attached, then attempt to HTTP to FI-A or open UCSM will result in the following error: "Login Error: Failed login info: UCSM is not available on secondary node"
In that case, ple...
Hi Pereira,Yes you can implement etherchannel on uplinks for the switch models you mentioned. To assist you with the configuration, here is a link to the official document: http://www.cisco.com/c/en/us/support/docs/lan-switching/etherchannel/12025-49...
Hi Vishal,A switch is an MDI-X device. That means the pin arrangement is as follows:Pin# Function1 Receiver+2 Receiver-3 Transmitter+6 Transmitter-So if you want to connect another switch to this switch, you have to make sure...