02-11-2016 09:46 AM - edited 03-01-2019 12:35 PM
When FI-A and FI-B is active, we are able to access the FI cluster GUI. When FI-A, failed we are not able to access the FI-cluster GUI.
It is normal or do we missing any configuration for failover.
02-14-2016 05:26 PM
Management services should failover automatically; however if they do not you can try logging into the CLI and running the following commands on FI-B.
connect local-mgmt
cluster force primary
02-14-2016 06:23 PM
When you log in to your Fabric Interconnect via a putty session can you paste the following command output:
Show cluster extended-state
is HA up and FI-A and FI-B both up?
02-14-2016 07:04 PM
In cluster mode, if the primary does not detect that a secondary FI is attached, then attempt to HTTP to FI-A or open UCSM will result in the following error: "Login Error: Failed login info: UCSM is not available on secondary node"
In that case, please check the ha state using the command:
connect local-management
show cluster extended-state
If HA is ready, please check the pmon processes to make sure all are running:
show pmon state
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide