Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Okay this is for another SPA9000, one that I can access through its web GUI unlike my previous post. It has software version 6.1.5. I understood that since version 5.2. 16 lines were supported by default, yet with mine only 4 are displayed. How are t...
Hi,I have a SPA9000 that I can't connect to, either using the configuration wizard or through the device's web GUI.The setup wizard fails to find or connect to the SPA9000.It gets a DHCP assigned IP address and responds to a ping. I've scanned the de...
Got a PIX 515, on power up none of the 3 lights on the front come on.No output at all from the console port.Link light and 100Mbps light adjacent to interface Ethernet1 are on with a cross over cable connected to a PC.Activity light on E1 comes on wh...
I have a strange issue with a Cisco PIX 515E.If I connect a crossover cable to the inside interface I can use either the Cisco ASDM Launcher application or a web browser and connect after entering the user name and password.If I connect my computer o...
Need some help please, either real world experience or a link to a guide\article.Situation - VPN 3005 concetrator, Win2K server with Exchange 2000 - back end server, Win2K server with Exchane 2000 - fron end server.Would like to use Concentrator as e...
Got there!I found previous versions of the firmware here http://www.voipipbx.com/index.php?option=com_rokdownloads&view=folder&Itemid=53Downloaded and upgraded incrementally to each version through to 5.2.5 then ran the set up wizard for the final st...
I need to ask for help with another issue now on the same device.It has software version 3.2.5(c) and when I try to upgrade using upg-spa9000t-6-1-5.exe it fails.I've also tried upgrading to 5.2.5 but this also fails, the process appears to proceed b...
Hi Patrick,I haven't been able to try anything since your last post until today.I followed your instructions but there was no change.What I have tried since and has worked is the following.After entering **** and accessing the IVS I entered 7932 and ...
Hi Patrick,I managed to borrow an analog phone today and used it to access the IVR on the SPA9000. I dialed **** followed by 73738#, which I understood to be the method to reset the device to its factory default settings.After the SPA9000 rebooted it...
No error messages in the log.PC has exactly the same static IP address.PIX is set up as a transparent firewall.I have now enabled http access from the same network on the outside interface as well as the inside.When I connect to the outside interface...
