Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, everyone. I have a question. Please help me. I am doing user authentication with 802.1x on a specific WLAN.And there is'enable session timeout' option in WLAN->Advanced.This option is the timeout value for re-authentication of the wireless dev...
Hello, everyoneI configured the GRE tunnel with 2 N9K.However, there is no keepalive option in N9K.How do I check the tunnel status between each other in N9K?I've seen some use of ip sla between both tunnel ips.In general, what method do you use?Than...
Hello,I need a help with meraki design.I have MX(2EA), MS_L3(2EA) and MS_L2(1EA).I'm going to construct it as below. I want to know if it is the right design.I want to get your advice. -> I think... the above design has a problem when the link down.H...
Hello,I need a help.I configed 3504 to HAIf HA completed, the manament ip will be one ip address.I have a SNMP collect server. the snmp server will add wlc ip address.which ip address should i do? (When HA is complete, the snmp is not active from se...
Hello.I have a question.We are using two N3548s consisting of STP and HSRP.N3548 is connected to each other by Port-Channel (10G * 2)And there's a firewall at the top, and a server at the bottom of each N3548.We want to migrate from this configuratio...
@balajiviswanathmohan wrote:Hi, Please see my comments below.If set to 60 minutes, will the wireless device re-authenticate after 60 minutes? - Yes it has to. The session timeout is the maximum time for a client session to remain active before requir...
