Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I noticed when I look at the clients on WCS that there is unusually high amount that say "probing." I know that these are clients that are not associated or authenticated yet. Is this normal?
I have a location where I am using a WGB350 going to an ATA186 then into a standard 2500 series telephone.Everyday the WGB will stop replying to pings, snmp requests, etc. It almost seems like it has lost power or connection. This will go on for ho...
I have set up an ATA186 for faxing. I am able to send faxing but can not recieve. It will ring and sounds like the fax connects but then I get a transmission failure.
I have had 4 350 series access points that all of a sudden will not allow clients to associate. All were running vx works 12.03T. There were no configuration changes made on any of them. Any ideas?
The problem started when we upgraded our AP's from 350's to 1231's. The way that I understood it was that when running multiple SSIDs on a 1231 AP it assigns a MAC to each SSID. On the 350's it just sent out all 0's. With the older versions of firm...
I am having similar problems with intermec CV60 units. They all show up as a repeater or bridge while our intermec 2415 units do show up as clients. Have you found a way to switch them to associate as a client?
I have not gotten it totally sorted out. It has to be some problem with the HP fax machine though. I have tried it with a different fax machine and it works fine. I have replaced the ata and it still didn't work. I turned off ECM on the fax and n...
