Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear ExpertI hava an issue with cisco ASA. In my ASA have three zone. like Inside, dmz, Outside. All DMZ server ip NATtranslation configure on Router which is connect with ASA outside zone. So when i wnat to ping from inside user pc to DMZ server pub...
Hi Expert
I can not pass RSPAN traffic through Nexus 3548 where it is intermediate switch in my network. my sources switch model cat3750 and collector switch is nexus 9508. N3k is in between them but it can not pass my RSPAN traffic. Is there any sol...
Hi Expert
I have a problem on Nexus 9508. I have two nexus 9508. our campus are using this switch as a gateway. we create 10-12 SVI interface on it. Problem is when we ping our gateway we face high latency and some time packet loss. But when we try ...
Dear Expert Please help.. I have a problem WSA transparent mode configuration. I share my Topology and ASA 5510 WCCP Status....-----------------------------------------------------------ASA5510---------------------------------------------------------...
I have two ASA 5585X-SSP20 need to Cluster config. I am little confused about ASA to Core Switch and Server Firm Switch Connectivity. In cluster mode if we config master asa two 10G port as an ether-channel then others cluster member same port config...
Thanks willwetherman.
Yes you r right. I create customize control panel services policy. But i cant customize default copp-system-p-policy-strict. Thaks again..
