Hi, This link might be helpful for you: http://www.cisco.com/c/en/us/td/docs/net_mgmt/ciscoworks_lan_management_solution/4-2/user/guide/workcenters/wcug/ew.html#wp1163049 Regards,Ernesto Q
Hello Mehdi,Marvin's note is correct, usually when DCRServer shows such state, the files that might be corrupted are:/opt/CSCOpx/MDC/tomcat/lib/ctm_config.txt/opt/CSCOpx/MDC/tomcat/shared/lib/ctm_config.txt/opt/CSCOpx/MDC/tomcat/webapps/cwhp/WEB-INF/...
Hello Dawit Zeru, Go to the Windows server where LMS was installed, open up a command prompt windows with administrator privileges and check the current Device packages from there as follows:cd LMSROOT\CSCOpx\binLMSROOT\PSUCli.bat -p cmf -q -all**LM...
Hi afsharki, One common situation is when LMS has debugs enable so that cpu resources are consumed fastly which causes as well slowness. Here are my recomendations: 1-Make sure there is no debug enable from:Admin > System > Debug SettingsCheck every ...
Hi Wilson, Could it be possible to have an output of a snmp walk using 1.3.6.1.2.1.2.2.1? It will display the current interfaces on such device via snmp. Regards,Ernesto Q