Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have just converted my unit of AP1200 to LWAPP by only copy c1200-rcvk9w8-mx into the AP and set AP to boot from this image. After which, I try have the AP associate the WLC. But it fails and keep reooting. Is there anyway to stop the AP fro...
Hi All,I wonder anyone have extend mutiple vlans over ethernet WAN. Please share your experience. I would want to consider implement trunking vlans over ethernet WAN between two office if it is feasible.
Hi All,Wonder anyone encounter these! I have catalyst switch running RSTP+ connected to AP1200 with vlans. The switch port that connect to the AP is configured trunk in order to transport vlans. Odd things happen when link on catalyst switch fail, th...
Hi All,I have a Cisco 1841 with a WIC-1T (V.35) which comes with a default configuration of clock rate 2000000. I use "no clock rate" and also "no clock rate 2000000", but i am not able to remove the command.This has cause the serial interface to go ...
Hi All,I just found out they are looking at 30MB etherWAN. I will connect my switch port to a fiber converter that terminate to the 30MB etherWAN link. Will I am not too sure whether this fiber converter has a 10/100 ethernet ?
Hi, you are right. I guess the reason my client want to do this is they have many server in this particular vlan, and they want to do the relocation at stages instead od one at a go.
Hi Jeye,You are right! This is our temporary solution ! The reason is that we would like to relocate some of the servers over to the new office, but at the same time be accessible from both office.What I do want to know, is it is possible to implemen...
Hi All,Yes, the switch port that connect to the wireless AP need to be configured as trunk.eg. int fa0/1 switchport trunk encapsulation dot1q switchport trunk switchport nonegotiate switchport trunk allowed vlan A, BEach vlan ...
Hi,Are you connecting the Checkpoint to one Cisco 4006 or two Cisco 4006 ?what is the configuration on the Quad NIC, is it trunk or access ?Also, what is the config on the 4006, is it trunk or access.May be you should try:"switchport host" commandBy ...
