About n4niteshkumar

n4niteshkumar · 07-16-2019

Hi folks,I have installed Cisco 3845 router as PSTN gateway and terminated POTS line on voice-port 0/2/2 of HWIC module. Required configuration for voice-port and dial-peer is done as per standard. But I am unable to place/receive calls on pots line ...

n4niteshkumar · 10-06-2014

Can the switchport of 4-port HWIC card in 2811 router be used as trunk port to connect L2 switch?

n4niteshkumar · 07-18-2019

@Mohammed al Baqari wrote:show full debug. Also, do you have DSP module installed and compatible with3845****** remember to rate useful posts@Mohammed al Baqari wrote:show full debug. Also, do you have DSP module installed and compatible with3845****...

n4niteshkumar · 07-18-2019

Thanks for your response. DSP module is installed in PSTN but don't know whether it is compatible with 3845.Only the "debug vpm signal" is being displayed and no output for other debug like debug ccapi voice input.Can u specify what other debug logs ...

n4niteshkumar · 10-06-2014

Put ? symbol in # prompt and it will show u possible commands,here u can look for configuration related command.

Member Since	‎10-06-2014 06:00 AM
Date Last Visited	‎07-25-2019 07:52 AM
Posts	5

User Statistics

User Activity

Problem in voice-port of pstn gateway

2811 router

Re: Problem in voice-port of pstn gateway

Re: Problem in voice-port of pstn gateway

Put ? symbol in # prompt and