Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two vlans, vlan 100 (170.10.0.0/25) and vlan 200 (170.10.0.128/25)Vlan 100 is connected to router in interface gig0/0.1 and Vlan 200 is connected to router on interface gig0/0.2Now consider only for vlan 100i have a host with ip 170.10.0.1/25 ...
Can anyone help me with one doubt i have, i am designing a network for a organization in packet tracer (for practice). It has 3 locations and each office should have 200 employees with 65% redundancy (For IP address)....i am confused with 65% redunda...
If a device wants to communicate with another device, and if there is no DHCP server in the network and if the manual configuration of the address is not possible, how will the two devices on the same link communicate?
I have configured HSRP only for Vlan 100 Config filesFOR ROUTER 0 Router# sh running-config Building configuration...Current configuration : 1031 bytes!version 15.1no service timestamps log datetime msecno service timestamps debug datetime msecno ser...
can you please check the command again, there is no such command in packet trace,what we have isshow running-config sh interfaces gigabitEthernet 0/0.1
Router# sh interfaces gigabitEthernet 0/0.1GigabitEthernet0/0.1 is up, line protocol is up (connected) Hardware is PQUICC_FEC, address is 00d0.ff2c.ca01 (bia 00d0.ff2c.ca01) Internet address is 170.10.0.126/25 MTU 1500 bytes, BW 100000 Kbit, DLY 1...
Ok here is the complete details of n/wI have two vlans, vlan 100 (170.10.0.0/25) and vlan 200 (170.10.0.128/25). Both are connected to a switch and switch is connected to a router.Vlan 100 is connected to router in interface gig0/0.1 and Vlan 200 is...