Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are in the process of completing a trangle between our three main sites. Today we are a hub/spoke design using OSPF with Area 0 being at our main site and Area 1 and 2 at the other two. When we add the links between the other areas we need to deci...
This morning when trying to connect to our WCS I got an error that the service was not started. Looking at the NMS_SERVER service it stays in the starting state. I have tried uninstalling and reinstalling and am getting the same results. When I do a ...
We have several devices on our network that are spread out over several buildings. These devices are unmanaged as far as patch and antivirus levels. I was thinking that I'd be able to setup a second vlan on each swtich these devices are connected to,...
We ran into a problem the other day where we added an IP Address to an ethernet interface on a 2620, brought the interface up, but could not ping that address space. we did not add a network statement under ospf so the segment would stay local to the...
Hi,We also have a TAC case open, but have not been able to find a solution to date. We are looking at rebuilding the server and trying to restore a backup of the WCS.
Thanks for the input on PBR. somehow that slipped my mind. Putting in a route-map only allowing the isolated network segment and directing it through the tunnel worked. I am static routing the iso network subnet on the IPS 6500 back through the tunne...
Here's the show ip route command from the router:WanDE1#sh ip route 192.168.0.0Routing entry for 192.168.0.0/24 Known via "ospf 1", distance 110, metric 20, type extern 2, forward metric 131 Last update from 129.176.180.57 on Serial0/0, 00:00:43 ag...
We do have IP Classless turned on. The users behind this router do not need to get to the OSPF 192.168 address space, so there would be an issue there.Here is a copy of the config:!version 12.3service timestamps debug datetime msecservice timestamps ...
The interface was in an up/up state, but we were not able to ping from the address from local router. The only way we could see this connected route is by doing a show ip route connected, or sho ip route 192.168.0.0 longer-prefix. either command did ...
