Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,How can I list the configuration applied to all users and group on ACS (in just one file)? There are around 300 users.Basically I need the information about maximum sessions by each user (can be on .txt or .csv file).I think this information is av...
Hi,After replacing a WS-X6548-GE-TX, I cannot configure the ports as ?switchport?:swit(config)#interface gigabitEthernet 2/48swit(config-if)#switchport swit(config-if)#switchport mode access Command rejected: Gi2/48 not a switching port.If I change t...
Hi,Does anyone know why I can only import the default route learned by EIGRP (from a CE router) in the VPNV4 table with the command ?network 0.0.0.0? under the address family? Is this the correct behavior?router bgp 100address-family ipv4 vrf red red...
Hi,Does Cisco support RFC3477 (Signaling Unnumbered Links in Resource Reservation Protocol - Traffic Engineering - RSVP-TE)?If yes, how can I configure it?I?m using Cisco7200 with version 12.0S (c7200-p-mz.120-32.S7.bin) and my TE-tunnels do not come...
Hi,I tried clearing the entire configuration module and did not work. I replaced the line card for a new one and did not work too.Only with the version upgrade it worked.Thanks a lot for your attention.Regards,Marcelo
Hi,The problem was due a BUG in the version. With the upgrade it is working.Old version: c6sup22-psv-mz.121-19.E1aNew version: c6sup22-psv-mz.121-27b.E3.binThanks,Marcelo
Sorry Iris, I think there is a misunderstanding on my question (it is not well written).I mean that if it is possible to signaling a TE tunnel through unnumbered links (RFC3477). The RSVP-TE should have some extensions to support this kind of signali...
