Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.
We have installed two ISE nodes, version 2.3, successfully imported configuration from ACS 5.8, all seemed to work properly.
But, after installation of patches 1 and 2, now in Device Administration -> Network Resources -> Network Devices, we c...
Hello.
I'm trying to configure our phones to be blocked until a user login to it.
I've understand (is it right?) that I must use extension mobility.
I've added the profile and subscribed the phone to the ext-mob service, and using the phone "services...
Hello.
Is it possible to use WSA for FTPs proxying?
We are using it for FTP proxy, but now we need to use it in this way:
Client -----FTP----> WSA -----FTPs-----> Server
Thanks
Daniele
Hello.
We have an old asa 5510, and we'd like to change it with a new asa 5525x with firepower services, to use IPS fueatures.
In the production firewall we are running 6 security contexts; so, the question is: if we buy this product, can we use IPS ...
I've an integration CUCM--Lync with one single trunk.
I'm trying to configure a second trunk to a second lync server.
I've tried this settings adding a second "destination address" in the sip information of the trunk configuration, but I'd like to us...
I've found the "solution": I couldn't see the SIP trunk in the RG baceause I had used it as a direct gw in the route pattern.
Now I have two sip trunk to Lync, configured in the RG in Circular mode; the problem is that when one of the two Lync SIP tr...
thanks Ayodeji
but the problem is that in the RG I cannot select a sip trunk... (and it's the reason for which I've added the second ip in the trunk config)
I've selected the first one directly from the route pattern, but I can select only one trunk ...
