Looks like I am getting the same behavior on the newer controller code, i.e., after the device sent the deauth or disassoc frame to the AP and it was acked by the AP, the client would still remain on the controller client list for a few minutes.  Eve...

Hello, I was wondering if there was a way to filter packets based on IP address at a particular LWAPP access point.   The autonomous access points allow packet filtering, seems like there should be a method at the LWAPP controller level also to filte...

Hello, I'm attempting to filter IP packet traffic based on MAC address using a 2960 switch.   I have several questions, are there any debug commands to view the success or failure of the mac address filtering?   The wireshark packet display is furthe...