Filter packets based on IP address at LWAPP access point.

[farondc2007]

Hello,

I was wondering if there was a way to filter packets based on IP address at a particular LWAPP access point.   The autonomous access points allow packet filtering, seems like there should be a method at the LWAPP controller level also to filter packets.

Regards,

Douglas Faron

[Rasika Nayanajith]

In WLC based solution, you can apply an ACL  per interface or per WLAN. So there is no specific way of apply it to a single AP.

Here is some basics of ACL in WLC based on 7.0.116.0 code

http://mrncciew.com/2013/03/15/wlc-access-control-list-acl/

HTH

Rasika