Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Was curious if we could specify the line a key on the 500DS should use. The reason for this is that theres different PBX's connected to this phone. Example:Key1: fnc=sd;sub=ext@$PROXY (Use Line 1 of 525G2)Key2: fnc=sd;sub=ext@$PROXY2 (Use Line 5 of...
We Need some more information.What does the network look like?What type of interfaces are you using?What tpe of router?What IOS on the router?What ISP?
Have you tried load balancing it without the IP SLA? Meaning set the default route with a low metric and then theo ther with a slightly higher metric. That way only the main route will be used unless its down.
I only see a ip route for Dialer1 which would be the ADSL. Have you tired addingip route 0.0.0.0 0.0.0.0 Dialer1ip route 0.0.0.0 0.0.0.0 FastEthernet0/1With different metrics ofcourse?
Dave, ppp chap hostname 01616812609@talktalk@net ppp chap password 0 That shows a username of 01616812609@talktalk@net and no password. Make sure that is correct.Also, I dont see a ip route 0.0.0.0 0.0.0.0 Dialer1 anywhere.
