Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I have a IPSEC VPN tunnel between StrongSwan and Cisco ASAs. The Cisco ASA will bring up the tunnel if the network behind the ASA (192.168.2.0/24) pings the network behind the Strongswan VPN (10.0.66.0/24). I want the tunnel to remain always ava...
have two Cisco Nexus switches with EIGRP Routers.
Switch 1:
SWITCH1(config-if)# sh run
!Command: show running-config !Time: Sun Feb 21 05:29:57 2016
version 5.0(3)U5(1f) no feature telnet no telnet server enable feature eigrp feature interface-vla...
My network is allocated a total of 16 Public IP addresses, and my internet interface routes these to an ASA firewall. I would like to limit the traffic entering / exiting the public interface by the IP address it is destined to:
For example:
2.2....
Hi Philip,
Yes, the VPN comes up as soon as I start or restart strong swan. My issue is that it goes down after about an hour and stays down until a system on the other side pings me. Is there a way to have the ASA ignore the idle timeouts regardless...
