Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Community,I have a setup where the Meraki MX is handling:Inter-VLAN routing, DHCP services, Firewall rules for VLAN-to-VLAN trafficMeraki switches and APs are also part of the same network, and the clients are connected via these switches.Now, I w...
Hi, I am planning to replace MV32 that went faulty due to weather conditions with a new model. Since I'm new to this product, I would appreciate any guidance you could offer on the best practices for replacing the MV. I was considering connecting the...
Hi Community ,I have been experiencing VRRP failover events between our Primary and Spare MXs since upgrading to Firmware MX 19.1.7.2. The failover and failback occur within a few seconds. Prior to this upgrade, when we were operating on MX 18.211.2 ...
Hi, We have the below switches in the topology. The access switches connect to the Core switch using Agg ports.Core Switch (Stack of 4) 3 - MS225-48 & 1- MS225-48FP3 access switches - MS125-48FP & MS120-8All switches are running on firmware 15.22 Co...
Hi Community, Recently high bandwidth consumption on WAN was reported & i was provided a list of DCs & AP (MRs) that were seen downloading & uploading data. This was captured on the gateway (L3/FW) which is managed by a different vendor. I'd like to ...
Test 1 If I'm roaming with more than one AP the device will never authenticate.What is the "SSID mode" for Client IP Assignment ? If its "Meraki NAT mode" please note that each AP will NAT to its own management IP address. As a result, connections wi...
Yes, its on basic:collect generic traffic categories. I'll change it to detailed:collect destination hostnames. Need to make these changes for each network.Thank you @Philip D'Ath
