About David Nolasco

David Nolasco · 08-15-2022

Hi, In rommon try to initialize the flash using "flash_init" command, if this does not help I would suggest to try the Emergency Recovery Procedure If still the device is unable to boot, most likely need to be replaced. Regards David N.

David Nolasco · 08-15-2022

Hi, It might be expected to see MAC move/flap notifications when it comes to wireless as users are moving around. The MAC-move counter notification generates a syslog message when the number of MAC moves in a VLAN exceeds the maximum limit. The maxim...

David Nolasco · 08-11-2022

Hi, The info you are looking for is here: L2 Performance IPv4 Performance The tables are specifically for a 9200L-24P-X. There are tables for each type of model and also for IPv6 performance and Multicast performance. I would suggest to get in touc...

David Nolasco · 01-26-2018

Please post the following outputs from both interfaces that belong to port-channel: show platform qos queue stat gig 6/0/24 show platform qos queue config gig 6/0/24

David Nolasco · 01-25-2018

Hi, - Is this a 4k or 6k in VSS? - Whats the code running on this device? - Which switch is the active one, switch #1 or #2? There are some issues where standby switch wont forward the packets. Regards David

Member Since	‎11-18-2014 10:24 PM
Date Last Visited	‎12-08-2025 02:30 PM
Posts	21
Total Helpful Votes Received	31

User Statistics

User Activity

Re: WS-C3850-24U-L does not boot

Re: When will %SW_MATM-4-MACFLAP_NOTIF: be generated?

Re: Cisco Catalyst 9200 latency

Re: C3850 output drops

Re: VSS Problem - Port Channel