Hello, I have not been able to find any documents that state the Ingress Protection Rating for Cisco's outdoor antennas, such as the AIR-ANT2506. Does anyone have current information on this? I'll put a request to Cisco pre-sales, and IF i get a response ill post it in here as well (though very unlikely) Thanks Blake ... View more

Hi, Can anyone tell me whether you can use DWDM-SFP10G modules on a WS-X45-SUP7-E? I know I can use X2 with a 4606-x2 (only have 1 in the chassis) but i want to split between two line cards for failure tolerance. None of the Cisco documentation mention DWDM-SFP10G for the SFP+ ports on the SUP7 Has anyone tried it? Thanks Blake ... View more

Hi, I had a working server running ISE version 1.1.0.665 but someone in the build room decided to pull the power out of the server rather than shutting it down correctly. I have booted the server back up however the web management page was not accessable. I have checked the server status and the end result is the Application Server in the "still initializing" stage. I have left the server for several hours and the status has not changed. I know people have previously run into this issue but no one has posted any resolution or confirmed that a rebuild is the only solution. Can someone please inform me if a solution to this issue exists. I have tried to create an on-demand backup but it seems to fail when attempting to provide the credentials (which are correct) for the FTP server. ... View more

Hi, I am in the process of testing a solution for a client and I have run into an interesting issue where a Windows XP laptop connected to the 3560 running c3560-ipservicesk9-mz.122-55.SE5 displays 192.168.1.2 as its IP within IP device tracking. I have tested with 802.1X & MAB with the same 192.168.1.2 however the device is recieving the correct IP address via DHCP. I am in the process of trying to verify if it is the laptop or Windows XP, but I thought I would post to see if anyone has experienced this before? A more indepth rundown of what I have running is ISE1.1 with multiple rule matching to provide inacl entries depending on the AD security groups the user has, the switchport is configured with MAB & 802.1X in that order but with 802.1X with the higher priority. Authentication is working correctly as the ISE is providing the inacl entries to the switch but as device tracking has the wrong IP, the acl applied to the port does not allow access for the end device. Thanks Blake ... View more

Hey, has anyone else experienced this after upgrading the firmware on the Wireless controller? I loaded AIR-WLC4400-K9-4-1-190-5-MESH onto the controller to follow the upgrade path and after it pushed the newer firmware to the AP it no longer boots correctly, the status lights say firmware error, but the image does load without grabbing an IP address and LWAPP association. I am about to attempt a recovery using the files from another AP. ... View more