Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI have a costumor that has set up two 8510 in AP SSO mode using version 7.4 between two data centres. The redundancy port is connected using a flat vlan spanning the two centers. I know that this is not recommended, but this is how it done.Now read...
I have a device manufacture there are requesting the following change on a customer's WLC 5508. config advanced eap identity-request-timeout 60config advanced eap request-timeout 60 I have studied many guides but I can't find out if there is a down-s...
I have an installation with both AIR-CT5508 and AIR-CT8510 controllers and 3602 access points. We have a couple og log messages that we are unable to find out what means. The installations being done together with a costumer that is very keen on vali...
I have searched and asked round for this the last weeks. Can't find the answer.When a flexconnect is in standalone mode (WAN down) what happens if the AP is reloaded?Is it possible to make a setup with i.e. WPA/PSK where the AP keeps working after a ...
After a crash of a MSE last week we have 8 critical alarms i Cisco WCS. One for each WiSM IPNMSP Connection Status: INACTIVE, Controller IP: <IP>The alarm is created the same time as the MSE crash.The "NMSP Connection Status" show ACTIVE and the trac...
Hi Christian
It is possible, but not if your WLC uses a static anchor to tunnel traffic to the inside WLC.
I filed a SR for this and we worked with TAC on it for weeks before they realized that this in an undocumented limitation.
We have created a...
Hi Patrick Did you find a solution to this. I seem to have the same issue with a teleworker solution. As I understand it this is a new bug in 8.x Would using 7.6 solve it? Regards Rasmus Sindum
You mention neighbours networks. It could very well be a 2.4GHz congestion issue.If you laptop and your network coverage supports 5GHz connection I would recommend to do at test where you disable 2.4GHz on the SSID. I have done this succesfull on man...
I agree a 100% I'm trying to get permission to implement a routed design with different subnets in the two DC. But for now I just need to understand the AP SSO solution./Rasmus
