cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
422
Views
5
Helpful
6
Replies

Flexconnect split tunneling in 8.0

patrick.kofler
Beginner
Beginner

Hi all,

Perhaps someone here can help me further. I'm trying to configure split tunneling on the wireless controller which is running code 8.0.110.0.

I've followed the config guide. I created the Flexconnect ACL, defined the interesting and bound it to the Flexconnect group. However the interesting traffic is not locally switched. When I tried to do it on a WLC running 7.6.130.0 it is working perfectly.

Did I miss a new parameter, which needs to be defined?

 

Regards,

Patrick

6 Replies 6

patrick.kofler
Beginner
Beginner

After TAC has been involved it was confirmed to be a bug.

Would like to see bug ID information if you have

Rasika

Hi Rasika,

The bug is CSCut91036. However the workaround stated does not work, as I have tried reconnecting the client multiple times.

Regards,
Patrick

Hi Patrick

 

Did you find a solution to this. I seem to have the same issue with a teleworker solution. As I understand it this is a new bug in 8.x Would using 7.6 solve it?

 

Regards Rasmus Sindum

Hi Rasmus,

It is working on 7.6. It's beyond me why Cisco decided to terminate this bug as the workaround clearly does not work.

Regards,
Patrick

To bad

 

I'm using a new 5520 controller. No 7.6 software for me.

I might have to run a TAC case on this.

 

Thanks for following up

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers