Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Friends,I am trying to configure a 2921 router with two number of ASA 5515 (both firewall is in Failover bundle) Firewall with Portchannel bundle.Router | Gig0/1 -----> Eth 0 for ASA -1 (Portchannel 2) | Gig0/2 ------> Eth 0 for ASA -2 ...
Dear Friends,In our network, we are using Citrix based VDI infrastructure. Citrix and VDI servers are in another location and we are connecting through MPLS link.I sniffed the Citrix packets in LAN and found that communication between Citrix server a...
Hi friends,One of my friend told that, most MNC company are pushing their Router/Switch/Firewall configuration through Script.Please let me know, how is it possible. If you have any other links to support the same.Please send the link details.I have ...
Hi friends,I have some doubt on the following scenario. Internet router------------------> Internet firewall----------------> Dept firewall--------------> users1.2.3.50 1.2.2.1/29 1.2.2.2/29 1.2.2.9/29 1.2.2.10/29...
Hi Friends,I have one query on failover of the link routing in core switch.My primary link is MPLS which is connected from MPLS router to Coreswitch, So whenever MPLS goes down then the traffic should route to IPSec Site to Site VPN tunnel through I...
Hi Mohammed,I was planned to do portchannel for a single router with two interface of the routers.I agree, if we want to do portchannel on the switches, it should be stacked mode, then only the Portchannel will effective.Another thing is, I am using...
Thanks Pille for your reply.I was in vacation, So I am not able to reply it.I will try the solution, because I heard the IRB technology newly.Surely I will come to you next day..Regards,Saravanan
Hi Pille,To create a Bridge-group, I need L2 switch right?, to connect the router and both ASA firewalls.I want to avoid L2 switch in between Router and Firewall, because It may be PoF (Point of Failover).If my understand is wrong, kindly explain cl...
Thanks for your reply Pille,Is any alternative design for the requirement, I don't want to put one L2 switch in between the router and firewall.Kindly suggest any other design plan for the same.
Hi Sharifi,Ether summary is blank for the router, but I have configured it.While configure channel group in Router interface, I can choose only the Po No, but I am not able select the mode active/onPls check the configuration in below.Router Interfac...
