Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have an issue where after calls have cycled through an ephone-hunt list it will not go to the voicemail of the original called extensionMy configuration is as followsephone-dn 50 dual-line number 6700 label Reception description 6700 name Rece...
Hi,One of our remote offices is having real issues with Wireless connectivity.The errors we have been receiving are as follows:Event5440 Endpoint abandoned EAP session and started newFailure Reason5440 Endpoint abandoned EAP session and started newRe...
I have been asked to add a 7925G IP Wireless phone to a Call Manager Express at one of my sites.Does anyone know of any good documentation that shows the process for doing this.I think I need to do the following but am not 100% sure on all the steps ...
Have got ISE 1.2 running and have my firewalls authenticating against them and need to get my IPS modules authenticating as well but don't seem to be able to get them to.My settings on teh IPS Device are as followsServier IP Address - {ISE Address}Au...
Hi,I've initiated a Full on demand Backup of my Administration node yet nearly 24 hours later I've still got nothing in teh Backup History and when checking the logs I can this message pretty much every hour on the hourExiting DB cleanup as ISE backu...
Hi neno, I think latency is the issue as here are the steps 11001Received RADIUS Access-Request 11017RADIUS created a new session 15049Evaluating Policy Group 15008Evaluating Service Selection Policy 15004Matched rule 15048Queried PIP 15048Queried PI...
Hi Tarik,Here is the condition used in my Authorisation Policy for allowing access to the IPS moduleActiveDirectory:ExternalGroups EQUALS {AD Group of which I am a member} ANDNetwork Access:AuthenticationMethod EQUALS PAP_ASCII ANDRadius:NAS-IP-Addr...
Thanks Jatin,That is what the problemwas along with not applying to the VTY lines which left the Authentication as a global setting rather than per line.Thanks agin for your helpJason
