Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,I have a Swedish customer with a SPA3102 and a Siemens DECT Gigaset 910 with one single problem. The Siemens does not ring on incoming calls. Outgoing calls are perfectly fine and incoming calls ring normally on any phone other that the Siemen...
Hi all,I have a customer with 2 SPA942's connected to a Sipxecs IP PBX. CTI is enabled on both phones, still the configured Line Key remains Solid Amber.I was able to find a thread showing that this is an issue with that specific PBX and the SPA942. ...
Dear Customer,
The hardware version should not affect the cluster functionality. If you wish, please send me your serial numbers as a private message and I will check them for you.
I can also make sure that a service request is opened for you.
Than...
Dear Customer,
Please send me your Cisco ID and the serial number of the device as a private message and I will make sure a service request gets opened for you.
Thanks.
Dear Customer,
Please send me as a private message the following:
1. The serial number of your access point
2. Screenshots of the label and the summary page within the gui
3. Your Cisco ID
Thank you!
Dear Customer,
Could you please send me as a private message all serial numbers of your WAP571Es access points along with your Cisco ID. I will make sure a service request is opened for you.
Thank you!
Dear Christophe,
The UPnP functionality is usually implemented on routers, so you may want to check your router for that setting. As for isolation, the WAP121 has a feature called "Channel Isolation" which is meant to isolate the connected wireless...
