Cisco Community
English
Register
Register
cancel
turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
deangeloj
‎08-18-2017
deangeloj
Member since ‎02-03-2007
Beginner
5
Posts
0
Helpful
0
Solutions
Recent Badges
Awards

How to disable a user account and issue...

Created by deangeloj Beginner in Policy and Access
‎06-19-2013 10:53 AM
‎06-19-2013 10:53 AM
Like the subject line says, I need to disable user accounts via REST, as well as issue CoA doing the same. Is this even possible? I've been trying for a few days now and I can do GET queries on user accounts, but I can't get anything to work using PUT. ... View more

Re: Problems w/ ASR 1002 & SPA 10GE car...

Created by deangeloj Beginner in Switching
‎10-31-2008 08:38 AM
‎10-31-2008 08:38 AM
Nice. Turns out the SPAs are LR and the Nexus 5020 the ASR trunks to is all SR. ... View more

Problems w/ ASR 1002 & SPA 10GE cards

Created by deangeloj Beginner in Switching
‎10-29-2008 12:02 PM
‎10-29-2008 12:02 PM
The 10GE SPA interface cards have two LEDs, one for status and the other for link. Both are illuminated, but there is no fiber connected to the cards and I cannot figure out if the whole ASR is bad, or just the cards. Also, the ASR's "boot" LED is constantly blinking, so I'm thinking *something* is messed up with this boat anchor. Any ideas on what to test or look for? Out of curiosity, is there any way to session into the ESP-10 that's installed like you would with a line card on a 6500? I didn't see anything indicating you actually move from card to card like that with the ASR series. ... View more

IPSEC/SPA: VRF w/ Tunnel Protection + S...

Created by deangeloj Beginner in VPN and AnyConnect
‎10-04-2007 11:30 AM
‎10-04-2007 11:30 AM
I'm developing a config for VRF w/ Tunnel Protection and Stateless failover on our IPSEC/SPA modules between a pair of 6513s. I have the basic config, but I'm getting stuck trying to get the tunnel working in concert with failover. ... View more
Labels:

Re: PIX downgrade basic question

Created by deangeloj Beginner in Firewalls
‎02-03-2007 11:09 AM
‎02-03-2007 11:09 AM
Do not load an older version of the PIX OS once you've upgraded to 7.x From the 7.0 release notes: Downgrade to Previous Version To downgrade to a previous version of the operating system software (software image), use the downgrade command in privileged EXEC mode. For more information and a complete description of the command syntax, see the Cisco Security Appliance Command Reference. -------------------------------------------------------------------------------- Caution Do not load a previous version of software if your PIX security appliance is currently running PIX Version 7.0 or later. Loading a software image from monitor mode, on a PIX security appliance that has a PIX Version 7.0 file system, results in unpredictable behavior and is not supported. We strongly recommend that you use the downgrade command from a running PIX Version 7.0 image that facilitates the downgrade process. ... View more
Public Statistics
Date Registered ‎02-03-2007 10:31 AM
Date Last Visited ‎08-18-2017 04:03 AM
Total Messages Posted 5
Helpful Votes Given To
View All