Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,This also applies to netconf.When router has ACL with ACE like permit tcp xxxx xxxx establish its not shown when doing get.ACE with permit tcp xxxx xxxx ack or other flag is shown when doing get.Checked with IOS-XE release 16.9.Any help appreciate...
Hi,Is there a way when provisioning VMs to create a a vCenter folder and put the VMs under this folder.For example creating ACI tenant for a customer and provisioning the VMs into new vCenter folder with customer name.I have seen the option under com...
Hi,
I am testing the csr1000v with openstack.
I have noticed that after power outage the router either boot into grub (esc not showing anything) or booting with new image.
Have tested with two different X86 hardware and killo/liberty with disk write ...
Hi,
I have tested with several x86 systems csr1000v running on top of openstack, and almost every time that I plug out power cord the router boots into grub.
I have disabled disk write cache but did not help.
This is not happening with other vnfs.
An...
HiFrom the below link below it mentioned that "Round-trip latency must not exceed 300 milliseconds (ms) between the AP and the controller. If the 300 milliseconds round-trip latency cannot be achieved, configure the AP to perform local authentication...
Hi,It's easy to reproduce, just create ip extended access list like below example with established ACE:[cid:image001.png@01D63CA9.0EEEF810]Now perform get to the router configuration or ACL or ACL stats and you won't see the ACEs with TCP established...
I see that your doing Nat.Check how many active translations you have.The default timeout for Nat entry is 24 hours.If you have over 30000 active entries change the timeout.You can also verify with show process memory before and after clearing IP Nat...
HiThank you for your response.I see it as a cookie at the client http header response.however it dose not have a name to use fore sticky.cant i configure http-header with cookie?thanks
