Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello there,
I want to set up the following network using a 3560 L3 switch:
Have 2 different ISPs come into a L3 3560 (running adv IP services) which will be connected to FW. The FW will then connect to a L3 LAN switch for inter-vlan routing. All ...
Hi there, I have a problem that has cropped up a second time in the last 6-7 months whereby I am not able to do a sho run (from enable prompt) on my Cisco 4507. I can do other show commands but no sho run. When I try and look at the nvram file wher...
Hello there, I want to restrict users' access to switches such that they can do all the show commands, ping but no config t. Right now, we use an SSH acl to allow the various subnets onto the network and we use TACACs+ for AAA. With that being sai...
Hello there, I'm adding ACLs to lock down the LAN environment and my core is a 4510+R. I want to block port 80, 443 and 8080 from coming INTO the network. My security guy tells me users use port 80, 443 and 8080 to get out and web services use othe...
Hello there, I am having an issue with 7960/7940 phones and their connected pcs authenticating with 802.1x. I read a post that an individual had in 2009 but it doesn't quite describe the situation I'm having and cannot figure out. I know that the 7...
RE: I've ran into this same issue. If you configure and enable aes password encryption and type your clear text keys in again the issue goes away. It appears it's something about reading in type 7 passwords that there's an issue with, but only with ...
Philip,
Yes, it's a 3560G-48TS-E V06. I don't have an 892F, but we're shelving this project for now so I can put it on the back burner. Don't know when we'll get back to it so thank you for answering!!
Kiley
Leo,We rebooted the switch and can do a show run - but only from the console. We still cannot do a show run from the vty lines. We can now look at the nvram from both the vty and console lines; however, when I do a copy run start - from the console...
Leo,the IOS is: 15.0(2)SE2. This particular user is on a 3750V2-48PS #sho mac address-table int fax/x/xMac Address Table-------------------------------------------Vlan Mac Address Type Ports---- ----------- - ...
