Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just wondering if anyone else has run across this error? %MAINBOARD-3-I2CRW_ERROR: Write failure - Device @ 0xE0, offset 0x00000000 on I2C bus 1The error message decoder was not helpful and TAC hasn't been able to tell us what the issue is. They'v...
We are seeing what we perceive to be, less than optimal data throughput rates between the 1142 and the Intel 5300AGN.Configured as follows:WiSM w/ 6.0.182.0 code1142AGNWPA2-PSK AES802.11b radio OFF20MHz channelsWMM EnabledDell Latitude E5400INTEL 530...
Scott,Did you ever figure out what the problem was? We've been running Nortel and Cisco for a couple of years now and Centurylink just upgraded the Nortel from 5.0 to 7.0. Now we are experiencing what you describe at two of our hospitals.Any help w...
4/24/2013 7:59:39 PM269: 008855: Write failure - Device @ 0xE0, offset 0x00000000 on I2C bus 1local use - level 723aman,Doesn't appear to be.TAC says this is caused by two processes trying to access the bus at the same time. (?) That doesn't make s...
aman,the link you provided was where we started. However, it doesn't tell you which component is the problem.router reboots just fine, no errors. We only get the error on ocassion and haven't been able to isolate what triggers it, so we can't repli...
